User`s guide

122 Chapter 3
Screen Reference
MANUAL TEST (GPRS Mode)
The following test items are shown in groups in the table. The detailed test screens
for the groups are displayed at the measuring state when selected by the CURSOR
CONTROL knob.
The following display fields remain blank at this state on the lower screen:
The RF ON annunciator at the screen lower right corner is displayed only when the
RF signal from the Test Set is present at the RF IN/OUT connector.
The instruction message “Press [Start] to begin a test.” is shown. By pressing the
Start softkey, the following idle screen is shown automatically changing from the
standby screen.
Test Item Description
Peak TX Power,
Power vs Time
The Measuring: Peak TX Power/Power vs Time screen is shown
with a result text and graphic display. If the marker function is
active, the Power Ramp value is displayed according to the
marker position.
Phase Error,
Frequency Error
The Measuring: Phase Error/Frequency Error screen is shown
with a result text and graphic display.
Sensitivity
The Measuring: Sensitivity screen is shown with a result text
display for BLER which is fixed in the Sensitivity field.
DC Current
The Measuring: DC Current screen is shown with a result text
display without titling Camp On nor Talk, if DC Power is set to
On and the dc power is supplied to the mobile under test.
Spectrum Monitor
The Measuring: Spectrum Monitor screen is shown with a result
text and graphic display.
Item Description
IMSI:
In the GPRS mode, the International Mobile Subscriber Identity
will not be displayed.
IMEI:
In the GPRS mode, the International Mobile Station Equipment
Identity will not be displayed.
Power Class:
Displays one of the defined factors. See "Power Classes" on page
184.
DC Current:
Displays the dc current consumed by the mobile at the connection
state, if DC Power is set to On and the dc power is supplied to the
mobile under test.
ACT Tim ADV:
Displays the number of bits for the actual timing advance data.