User`s guide

102 Chapter 3

Screen Reference

MANUAL TEST (Asynchronous Mode)

NOTE The Asynchronous mode is only available for Test Sets with Option 002 which

enables the signal generator and TX analyzer modes too. This option can be

installed with Option 040 for GPRS Mode

In the MANUAL TEST mode, each test item or a group of test items can be

measured and analyzed with the test limits specified in the Test Set: Test Condition

screen of the CONFIGURATION mode.

In the asynchronous mode, tests are made without networking the Test Set and the

mobile phone with each other. This mode is used to test the RF transmission

characteristics of mobiles in a real-time manner. Therefore, the receiver related

characteristics such as sensitivity, RX quality and RX level are not measured.

Also, the mobile related information such as IMSI, IMEI and so forth are not

available, however, DC Current is displayed under the test item table.

To test mobiles using the asynchronous mode, set the mobile to transmit RF power

independently (without sending a special command from the Test Set to the

mobile, for instance).

NOTE When entering numeric values, the variable increment softkey menu is displayed.

Refer to “Variable Increment Softkey” and "Storing Two Numeric Values" on page

59.

The default state is the last setting stored in the internal memory before power off.