Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 3 97
Programming Command Reference
TESTs Subsystem for MANUAL TEST
3. Programming Command
Reference
This query command returns a set of Power Ramp pass/fail result values,
<string 1> and <string 2>.
• <string 1> (1 digit) is 0 when all values are within the normal range, or 1 if any
measurement is overranged, underranged or not made.
• <string 2> (1 digit) is the binary data, 0 or 1, for the pass (0) or fail (1) result.
Timing Advance
TESTs:MANual:TXAMplitude:TADVance <integer>
TESTs:MANual:TXAMPlitude:TADVance?
This command specifies a value of Timing Advance. The allowable range is from
0 to 63 (bits).
NOTE For Test Sets with Option 002, if the mode is set to SYNC, this
command is valid.
Traffic Channel
TESTs:MANual:TPOWer:CHANnel <int>
TESTs:MANual:TPOWer:CHANnel?
This command specifies the channel number of Traffic Channel (TCH) to be tested
for each of the radio standards in conjunction with the Multi Band settings. The
allowable range and preset values are as follows:
Traffic Channel Frequency
TESTs:MANual:TPOWer:FREQuency
<real> [HZ|KHZ|MHZ|MAHZ]
TESTs:MANual:TPOWer:FREQuency?
RFORmat MBANd Allowable Range Preset Value
GSM900 DCS1800 1 to 124; 512 to 885 1
OFF 1 to 124
E-GSM DCS1800 0 to 124|975 to 1023;
512 to 885
1
OFF 0 to 124|975 to 1023
DCS1800 GSM900 512 to 885;
1 to 124
512
E-GSM 512 to 885;
975 to 1023|0 to 124
OFF 512 to 885
PCS1900 OFF 512 to 810 512