Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 3 93
Programming Command Reference
TESTs Subsystem for MANUAL TEST
3. Programming Command
Reference
Command Reference for MS Information
MS Information
TESTs:MANual:RESults:MSINformation:IMSI?
This query command returns the IMSI string of 15 letters.
TESTs:MANual:RESults:MSINformation:IMEI?
This query command returns the IMEI string of 15 letters.
TESTs:MANual:RESults:MSINformation:DIAL?
This query command returns the 20-digit dialed number string.
TESTs:MANual:RESults:MSINformation:PCLass?
This query command returns a 1-digit power class string.
TESTs:MANual:RESults:MSINformation:GVERsion?
This query command returns a 1-digit version number of the GSM mobile under
test.
NOTE For Test Sets with Option 002, if the mode is set to ASYNC, these
commands are invalid.
For Test Sets with Option 040, if the mode is set to GPRS, the
commands for DIAL and GVERsion are invalid.
Command Reference for Peak TX Power /Burst Timing/Power Ramp
Measurement Screen
The TPOWer and TXAMplitude commands are used to set or read the controls and
parameters associated with the Peak TX Power/Burst Timing/Power Ramp
measurements and the pass/fail tests.
Send the "DISPlay:MANual:TPOWer" command to display the Peak TX
Power/Burst Timing/Power Ramp screen for MANUAL TEST before sending the
following commands.
DCS1800 GSM900 1710200000 to 1784800000;
890200000 to 914800000
1710200000
E-GSM 1710200000 to 1784800000;
880200000 to 914800000
OFF 1710200000 to 1784800000
PCS1900 OFF 1850200000 to 1909800000 1850200000
RFORmat MBANd Allowable Range [Hz] Preset Value [Hz]