Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
92 Chapter 3
Programming Command Reference
TESTs Subsystem for MANUAL TEST
Traffic Channel
TESTs:MANual:MEASure:TCH:CHANnel <int>
TESTs:MANual:MEASure:TCH:CHANnel?
This command specifies the channel number of Traffic Channel (TCH) to be tested
for each of the radio standards in conjunction with the Multi Band settings. The
allowable range and preset values are as follows:
Traffic Channel Frequency
TESTs:MANual:TCH:FREQuency <real> [HZ|KHZ|MHZ|MAHZ]
TESTs:MANual:TCH:FREQuency?
This command specifies the frequency of Traffic Channel (TCH) to be tested, for
each of the radio standards in conjunction with the Multi Band settings. The
allowable range and preset values are as follows:
RFORmat MBANd Allowable Range Preset Value
GSM900 DCS1800 1 to 124;
512 to 885
1
OFF 1 to 124
E-GSM DCS1800 0 to 124|975 to 1023;
512 to 885
1
OFF 0 to 124|975 to 1023
DCS1800 GSM900 512 to 885;
1 to 124
512
E-GSM 512 to 885;
975 to 1023|0 to 124
OFF 512 to 885
PCS1900 OFF 512 to 810 512
RFORmat MBANd Allowable Range [Hz] Preset Value [Hz]
GSM900 DCS1800 890200000 to 914800000;
1710200000 to 1784800000
896000000
OFF 890200000 to 914800000
E-GSM DCS1800 880200000 to 914800000;
1710200000 to 1784800000
896000000
OFF 880200000 to 914800000