Specifications

70 Chapter 3
Programming Command Reference
TESTs Subsystem for AUTOMATIC TEST
TESTs Subsystem for AUTOMATIC TEST
This function allows to execute the overall measurements and pass/fail tests with
the automatic procedure. Test sequence and condition are configurable with the
CONFigure:SEQuence command and CONFigure:CONDition command.
NOTE For Test Sets with Option 002, the DC Power voltage setting made
in this function are copied to the MANUAL TEST, SIGNAL
GENERATOR and SPECTRUM MONITOR and vice versa.
All Tests Results (Detail)
TESTs:AUTO:RESults:WHOLe?
This query command returns all of the test results values, <string 1>, <string 2>,
...., <string 186>, for AUTOMATIC TEST.
<string 1>, <string 2>, <string 3>, <string 4>, <string 5>:
Peak TX Power results (TCH1) - Refer to “Peak TX Power Measurement” on
page 75 for the meanings of each <string>.
<string 6>, <string 7>, <string 8>:
Burst Timing results (TCH1) - Refer to “Burst Timing Measurement” on page
72 for the meanings of each <string>.
<string 9>, <string 10>:
Power Ramp results (TCH1) - Refer to “Power Ramp Test” on page 74 for the
meanings of each <string>.
<string 11>, <string 12>, <string 13>, <string 14>:
Phase Error results (TCH1) - Refer to “Phase Error Marker Measurement” on
page 76 for the meanings of each <string>.
<string 15>, <string 16>, <string 17>:
Frequency Error results (TCH1) - Refer to “Frequency Error Measurement” on
page 76 for the meanings of each <string>.
<string 18>, <string 19>, <string 20>, <string 21>:
Sensitivity results (TCH1) - Refer to “Sensitivity Measurement” on page 79
for the meanings of each <string>.
<string 22>, <string 23>, <string 24>:
RX Quality results (TCH1) - Refer to “RX Quality Measurement” on page 78
for the meanings of each <string>.
<string 25>, <string 26>, <string 27>:
RX Level results (TCH1) - Refer to “RX Level Measurement” on page 78 for
the meanings of each <string>.
<string 28>, <string 29>, <string 30>, <string 31>: