Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 3 67
Programming Command Reference
SMONitor Subsystem
3. Programming Command
Reference
This command defines a system of Radio Standard to be tested. The choices are
GSM900, E-GSM, DCS1800, and PCS1900. At preset, this is set to GSM900.
Resolution Bandwidth
SMONitor:RBWidth 10k|30k
SMONitor:RBWidth?
This command specifies a value of RBW (Resolution Bandwidth). The choices are
10k for 10 kHz and 30k for 30 kHz. At preset, this is set to 30k.
Traffic Channel
SMONitor:CHANnel <int>
SMONitor:CHANnel?
This command specifies the channel number of Traffic Channel to be analyzed for
each radio standard set by the Radio Format command. The allowable range and
preset values are as follows:
Traffic Channel Frequency
SMONitor:FREQuency <real> [HZ|KHZ|MHZ|MAHZ]
SMONitor:FREQuency?
This command specifies the frequency of Traffic Channel to be analyzed for each
radio standard set by the Radio Format command. The allowable range and preset
values are as follows:
RFORmat Allowable Range Preset Value
GSM900 1 to 124 1
E-GSM 0 to 124, 975 to 1023 1
DCS1800 512 to 885 512
PCS1900 512 to 810 512
RFORmat Allowable Range [Hz] Preset Value [Hz]
GSM900 890200000 to 914800000 890200000
E-GSM 880200000 to 914800000 890200000
DCS1800 1710200000 to 1784800000 1710200000
PCS1900 1850200000 to 1909800000 1850200000