Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 3 59
Programming Command Reference
DISPlay Subsystem
3. Programming Command
Reference
NOTE This command is valid only for Test Sets with Option 002.
Stand-by (GPRS Mode)
DISPlay:MANual:GPRS:STBY
This command selects the GPRS mode Stand-by screen for MANUAL TEST.
NOTE This command is valid only for Test Sets with Option 040.
Stand-by (Synchronous Mode)
DISPlay:MANual:SYNC:STBY
This command selects the synchronous mode Stand-by screen for MANUAL
TEST.
NOTE This command is valid only for Test Sets with any of Option 002
and Option 040.
Command Reference for SIGNAL GENERATOR Screen
RF Signal Generator
DISPlay:RFGenerator
This command selects the screen for SIGNAL GENERATOR.
NOTE This command is valid only for Test Sets with Option 002.
Command Reference for SPECTRUM MONITOR Screen
Spectrum Monitor
DISPlay:SMONitor
This command selects the screen for SPECTRUM MONITOR.
NOTE This command is valid only for Test Sets with Option 002.