Specifications

Chapter 3 57
Programming Command Reference
DISPlay Subsystem
3. Programming Command
Reference
Stand-by
DISPlay:AUTO:STBY
This command selects the Stand-by screen for AUTOMATIC TEST.
Command Reference for CONFIGURATION Screens
File Management
DISPlay:CONFgiure:FILE
This command selects the File Management screen. The files including test setups
for all function modes are saved in and recalled or deleted from an SRAM memory
card. Also an SRAM memory card can be initialized.
System Configuration
DISPlay:CONFigure
This command selects the CONFIGURATION screen. The parameters and
controls on this screen set the fundamental information for all function modes of
the Test Set.
NOTE “Serial Port” is not programmable but manually set.
Test Condition
DISPlay:CONDition
This command selects the Test Setup: Test Condition screen. The parameters and
controls on this screen set the test conditions for AUTOMATIC TEST and
MANUAL TEST.
Test Sequence
DISPlay:SEQuence
This command selects the Test Setup: Test Sequence screen. The parameters and
controls on this screen set the test sequence for AUTOMATIC TEST.
Command Reference for MANUAL TEST Screens
DC Current
DISPlay:MANual:CURRent
This command selects the DC Current measuring screen for MANUAL TEST.
Measuring
DISPlay:MANual:MEASure
This command selects the Measuring screen for MANUAL TEST.