Specifications

56 Chapter 3
Programming Command Reference
DISPlay Subsystem
DISPlay Subsystem
The DISPlay subsystem commands are used to select which of the Test Set’s
screens is being programmed. No query is available for these commands.
Command Reference for Initial Screen
Initial Screen
DISPlay:INITial
This command selects the initial screen for activating one of the function modes. A
test procedure can be selected from an SRAM memory card on this screen.
Command Reference for AUTOMATIC TEST Screens
Burst Timing/Power Ramp
DISPlay:AUTO:BTIMing
This command selects the Burst Timing/Power Ramp measurement screen for
AUTOMATIC TEST.
DC Current
DISPlay:AUTO:CURRent
This command selects the DC Current measurement screen for AUTOMATIC
TEST.
Peak TX Power
DISPlay:AUTO:TPOWer
This command selects the Peak TX Power measurement screen for AUTOMATIC
TEST.
Phase Error/Frequency Error
DISPlay:AUTO:PHASe
This command selects the Phase Error/Frequency Error measurement screen for
AUTOMATIC TEST.
Sensitivity/RX Quality/RX Level
DISPlay:AUTO:SENSitivity
This command selects the Sensitivity/RX Quality/RX Level measurement screen
for AUTOMATIC TEST.