Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
54 Chapter 3
Programming Command Reference
CONFigure Subsystem
bit 1 (2): For testing TCH2 or DCP2
bit 2 (4): For testing TCH3 or DCP3
bit 3 (8): For testing TCH4 or DCP4
bit 4 (16): For testing TCH5 or DCP5
bit 5 (32): For testing TCH6 or DCP6
The choices for each bit are 1 for Run and 0 for --- (skip). At preset, this is set to
63.
Talk Test
CONFigure:SEQuence:SIGNaling:TALK ON|OFF|1|0
CONFigure:SEQuence:SIGNaling:TALK?
This command defines whether or not to include the Talk step in a test flow. The
choices are ON (1) for Run and OFF (0) for --- (skip). At preset, this is set to ON.
Talk Test TCH Channel
CONFigure:SEQuence:TCH:CHANnel <int>
CONFigure:SEQuence:TCH:CHANnel?
This command specifies the channel number of Traffic Channel for Talk tests
when Variable is set to TCH, for each radio standard set by the Radio Format
command. The allowable range and preset values are as follows:
Talk Test TCH Frequency
CONFigure:SEQuence:TCH:FREQuency
<real> [HZ|KHZ|MHZ|MAHZ]
CONFigure:SEQuence:TCH:FREQuency?
This command specifies the frequency of Traffic Channel for Talk tests when
Variable is set to TCH, for each radio standard set by the Radio Format command.
The allowable range and preset values are as follows:
RFORmat Allowable Range Preset Value
GSM900 1 to 124 1
E-GSM 0 to 124, 975 to 1023 1
DCS1800 512 to 885 512
PCS1900 512 to 810 512