Specifications

52 Chapter 3
Programming Command Reference
CONFigure Subsystem
Phase Error Test
CONFigure:SEQuence:PHASe <int>
CONFigure:SEQuence:PHASe?
This command defines whether or not to include Phase Error tests in the test
sequence for the six measurements. <int> is a binary coded decimal ranging from 0
to 63 as follows:
bit 0 (1): For testing TCH1 or DCP1
bit 1 (2): For testing TCH2 or DCP2
bit 2 (4): For testing TCH3 or DCP3
bit 3 (8): For testing TCH4 or DCP4
bit 4 (16): For testing TCH5 or DCP5
bit 5 (32): For testing TCH6 or DCP6
The choices for each bit are 1 for Run and 0 for --- (skip). At preset, this is set to
63.
Power Ramp Test
CONFigure:SEQuence:RAMP <int>
CONFigure:SEQuence:RAMP?
This command defines whether or not to include Power Ramp tests in the test
sequence for the six measurements. <int> is a binary coded decimal ranging from 0
to 63 as follows:
bit 0 (1): For testing TCH1 or DCP1
bit 1 (2): For testing TCH2 or DCP2
bit 2 (4): For testing TCH3 or DCP3
bit 3 (8): For testing TCH4 or DCP4
bit 4 (16): For testing TCH5 or DCP5
bit 5 (32): For testing TCH6 or DCP6
The choices for each bit are 1 for Run and 0 for --- (skip). At preset, this is set to
63.
Radio Standard
CONFigure:SEQuence:RFORmat GSM900|E-GSM|DCS1800|PCS1900
CONFigure:SEQuence:RFORmat?
This command defines a system of Radio Standard to be tested. The choices are
GSM900, E-GSM, DCS1800, and PCS1900. At preset, this is set to GSM900. If
PCS1900 is selected, the Multi Band command is automatically set to OFF.