Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 3 45
Programming Command Reference
CONFigure Subsystem
3. Programming Command
Reference
NOTE If Option 040 is installed and the mode is set to GPRS in
MANUAL TEST, RX Level can not be measured.
RX Quality Limit
CONFigure:CONDition:LIMit:QUALity <int l>,<int h>
CONFigure:CONDition:LIMit:QUALity?
This command specifies the low and high limits for RX Quality tests. The choices
are 0 (<0.2), 1 (0.2 to 0.4), ......, 6 (6.4 to 12.8), and 7 (>12.8%). At preset, these
are set to 0 and 4.
NOTE If Option 040 is installed and the mode is set to GPRSin MANUAL
TEST, RX Quality can not be measured.
Preset Values
Choice RX Level [dBm] RFORmat Low High
0
<
−110
GSM900 5 12
1
−110 to −109
E-GSM 5 12
2
−109 to −108
DCS1800 7 14
..... ..... PCS1900 5 12
62
−49 to −48
63
>
−48