Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 2 31
Programming Command Guidelines
Using the Status Registers
2. Programming Command
Guidelines
Error Messages
The following table shows the error messages for the Test Set.
Table 2-4 Error Messages
Error No. Description
0 No error
−100
Other command error has occurred.
−103
Command error due to an invalid separator
−112
Command error due to a program mnemonic that is too long
−113
Command error due to an undefined header
−120
Command error due to a numeric data error
−123
Command error due to an exponent that is too large
−124
Command error due to too many digits
−131
Command error due to an invalid suffix
−141
Command error due to invalid character data
−144
Command error due to character data that is too long
−200
Execution error due to an invalid command
−222
Execution error due to data that is out of range
−350
Device dependent error due to a queue overflow