Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 1 15
Preparing for Use
Connecting to Controller
1. Preparing for Use
Connecting to Controller
A DB-9 male connector is provided with the Test Set as the serial interface to a
controller.
• If your PC controller has a DB-9 male connector, use the 9-pin female to 9-pin
female RS-232C cable between the PC and the Test Set. This cable must have
the pin assignments shown in the upper illustration of Figure 1-2.
• If your PC controller has a DB-25 male connector, insert the 9-pin male to
25-pin female Adapter between the RS-232C cable and the 25-pin male
connector. This adapter must have the pin assignments shown in the lower
diagram of Figure 1-2.
Agilent Technologies 34398A RS-232 Cable Kit contains a 9-pin female to 9-pin
female cable and 9-pin male to 25-pin female adapter.
Figure 1-2 RS-232C Cable and Adapter Pin Assignments