Specifications

156 Chapter 5
Example Programs
MANUAL TEST GPRS Mode Sample Program
1180 Sets the Packet Data TCH channel number to 60.
1190 Sets the Multi Band field to Off.
1200 Sets the DC Power mode to Off.
1210 Sets the Measured Slot to 4.
1220 Sets the Slot Configuration to 2×1.
1230 Sets the Sensitivity in BLER.
1280 to 1300 Displays the instruction message for you to do so.
1320 Sends a trigger with the continuous mode.
1330 Displays the MANUAL TEST GPRS Measuring screen.
1340 to 1380 Monitors the signaling state until it becomes Attached.
1420 Displays the Peak TX Power/Power vs Time measuring screen.
1430 Sets the trigger mode to Single.
1450 Sends a trigger to measure Peak TX Power/Power vs Time.
1470 to 1510 Monitors the status byte until one measurement ends.
1530 to 1540 Queries and enters the status and measurement results.
1550 to 1640 Prints the pass/fail test result and measured data.
1650 Displays the MANUAL TEST GPRS Measuring screen.
1700 Displays the Phase Error/Frequency Error measuring screen.
1710 Sets the trigger mode to Single.
1730 Sends a trigger to measure Phase Error/Frequency Error.
1750 to 1790 Monitors the status byte until one measurement ends.
1810 to 1820 Queries and enters the status and measurement results.
1830 to 1920 Prints the pass/fail test result and measured data.
1930 Displays the MANUAL TEST GPRS Measuring screen.
1980 Displays the Sensitivity measuring screen.
1990 Sets the trigger mode to Single.
2010 Sends a trigger to measure Sensitivity.
2030 to 2070 Monitors the status byte until one measurement ends.
2090 to 2100 Queries and enters the status and measurement results.
2110 to 2200 Prints the pass/fail test result and measured data.
2210 Displays the MANUAL TEST GPRS Measuring screen.
2240 Sends the measurement end command.