Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
14 Chapter 1
Preparing for Use
Equipment for Automated Test System
Equipment for Automated Test System
The following equipment is required to construct an automated test system:
• The Agilent E6392B GSM MS Test Set (called the Test Set hereafter)
• A system controller with the RS-232C interface
• An RS-232C cable
• An RF cable to connect RF signals from/to the mobile phone under test, or
the Antenna Coupler to connect RF signals from/to the mobile phone, or
the Shield Box (Agilent N4678A) to couple RF signals from/to the mobile
phone
• The Universal DC Power Adapter and an appropriate cable to connect between
the AUX connector of the Test Set and the mobile phone to supply the dc
power to the mobile phone from the Test Set (optional)
• Printer and an appropriate cable (optional)
A typical setup for an automated test system looks like the illustration in Figure
1-1 below:
Figure 1-1 Typical Setup for Automated Test System