Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
Chapter 4 149
Programming Command Cross Reference
System Control Function
4. Programming Command
Cross Reference
System Control Function
The following SYSTem subsystem commands are used to control and query the
system status of the GSM MS Test Set:
Table 4-20 SYSTem Subsystem Command Reference
Item Command
Lock System Panel :SYSTem:KLOCk ON|OFF|1|0
:SYSTem:KLOCk?
Softkey Memory :SYSTem:MEMory:AMPLitude <real 1>,<real 2>
:SYSTem:MEMory:AMPLitude?
:SYSTem:MEMory:CHANnel <int 1>,<int 2>
:SYSTem:MEMory:CHANnel?
:SYSTem:MEMory:PLEVel <int 1>,<int 2>
:SYSTem:MEMory:PLEVel?
System Error :SYSTem:ERRor?
System Setup :SYSTem:SETup <strings>
:SYSTem:SETup?