Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
144 Chapter 4
Programming Command Cross Reference
MANUAL TEST Screens
Sensitivity/RX Quality/RX Level Measuring Screens
The following SENSitivity/RX commands are used to set the controls and
parameters associated with the screens for Sensitivity/RX Quality/RX Level
measurements and Pass/Fail test results. For Test Sets with Option 002, if set to
ASYNC, these commands are invalid.
Table 4-15 SENSitivity/RX Command Cross Reference
Item Command
BER BS Level TESTs:MANual:SENSitivity:LEVel <real>
TESTs:MANual:SENSitivity:LEVel?
BER Frames TESTs:MANual:SENSitivity:FRAMe <int>
TESTs:MANual:SENSitivity:FRAMe?
DC Power Voltage TESTs:MANual:SENSitivity:DCPower:VOLT <real>
TESTs:MANual:SENSitivity:DCPower:VOLT?
Power Control Level TESTs:MANual:SENSitivity:PLEVel <int>
TESTs:MANual:SENSitivity:PLEVel?
RX Level Measurement
a
TESTs:MANual:RX:RESults:LEVel?
RX Quality Measurement
a
TESTs:MANual:RX:RESults:QUALity?
Sensitivity Measurement
b
TESTs:MANual:RX:RESults:SENSitivity?
Traffic Channel TESTs:MANual:SENSitivity:CHANnel <int>
TESTs:MANual:SENSitivity:CHANnel?
Traffic Channel
Frequency
TESTs:MANual:SENSitivity:FREQuency <real>
TESTs:MANual:SENSitivity:FREQuency?
a. Invalid when the GPRS mode is selected on the Test Set with Option 040.
b. Only BLER is measured when the GPRS mode is selected on the Test Set with Option
040.