Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
128 Chapter 4
Programming Command Cross Reference
CONFIGURATION Screen
System Configuration Screen
The following CONFigure subsystem commands are used to set the reference
oscillator source, date and time, beeper, RF attenuation, firmware update, and so
forth which are fundamentally required to operate the GSM MS Test Set.
Table 4-4 CONFigure Subsystem Command Cross Reference
Item Command
13 MHz Reference
Oscillator
CONFigure:ROSCillator INTernal|EXTernal
CONFigure:ROSCillator?
Attenuation CONFigure:LOSS ON|OFF|1|0
CONFigure:LOSS?
CONFigure:LOSS:RFIN <real>
CONFigure:LOSS:RFIN?
CONFigure:LOSS:RFOUt <real>
CONFigure:LOSS:RFOUt?
Beeper Control CONFigure:BEEPer ON|OFF|1|0
CONFigure:BEEPer?
Date CONFigure:DATE <int y>,<int m>,<int d>
CONFigure:DATE?
Network Config CONFigure:NETWork:MCC <int>
CONFigure:NETWork:MCC?
CONFigure:NETWork:MNC <int>
CONFigure:NETWork:MNC?
CONFigure:NETWork:NCC <int>
CONFigure:NETWork:NCC?
CONFigure:NETWork:LAC <int>
CONFigure:NETWork:LAC?
CONFigure:NETWork:BSPa <int>
CONFigure:NETWork:BSPa?
Panel Key Control CONFigure:PKEY UNLOCK|LOCK
CONFigure:PKEY?
Printer Control CONFigure:PRINter HPPCL|ESCP
CONFigure:PRINter?
Time CONFigure:TIME <int h>,<int m>
CONFigure:TIME?