Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
114 Chapter 3
Programming Command Reference
TESTs Subsystem for MANUAL TEST
This command specifies the slot combination for downlink and uplink,
respectively, in the Stand-by screen for the GPRS mode, in conjunction with the
Slot Measured setting. The combinations of the slot configuration and the slot
order measured are as follows:
At preset, this is set to 1 × 1.
NOTE If the mode is set to GPRS on the Test Set with Option 040, this
command is valid.
Slot Measured
TESTs:MANual:MSLot 4
This command specifies the order of slot to be measured, in the Stand-by screen
for the GPRS mode, in conjunction with the Slot Configuration setting. The
combinations of the slot order measured and the slot configuration are as follows:
At preset, this is set to 4.
NOTE As the slot order measured is fixed to 4 when the mode is set to
GPRS on the Test Set with Option 040, this command is invalid.
Timing Advance
TESTs:MANual:TADVance <integer>
TESTs:MANual:TADVance?
This command specifies the number of bits for the timing advance value. The
allowable range is from 0 to 63 bits.
NOTE If the mode is set to ASYNC on the Test Set with Option 002, this
command is invalid.
If the mode is set to SYNC or GPRS on the Test Set with Option
040, this command is valid.
Option Slot Configuration Slot Order Measured
040 Downlink 1 × Uplink 1 4
040 2 × 14
Option
Slot
Configuration
Slot Order Measured
040 D 1 × U 1 4 (fourth)
040 2 × 1 4 (fourth)