Specifications
Table Of Contents
- E6392-90042.pdf
- E6392-90042_manual
- Front Matter
- Contents
- 1 Preparing for Use
- 2 Programming Command Guidelines
- 3 Programming Command Reference
- IEEE Common Command
- CONFigure Subsystem
- DISPlay Subsystem
- HCOPy Subsystem
- RFGenerator Subsystem
- SMONitor Subsystem
- SYSTem Subsystem
- TESTs Subsystem for AUTOMATIC TEST
- All Tests Results
- All Tests Results
- Command Reference for Burst Timing/Power Ramp Measurement Screen
- Command Reference for DC Current Measurement Screen
- Command Reference for MS Information
- Command Reference for Peak TX Power Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Stand-by/Measuring Screens
- TESTs Subsystem for MANUAL TEST
- Command Reference for DC Current Measurement Screen
- Command Reference for Measuring Screens
- Command Reference for MS Information
- Command Reference for Peak TX Power /Burst Timing/Power Ramp Measurement Screen
- Command Reference for Phase/Frequency Error Measurement Screen
- Command Reference for Sensitivity/RX Quality/RX Level Measurement Screen
- Command Reference for Spectrum Monitor Measurement Screen
- Command Reference for Stand-by Screens
- TRIGger Subsystem
- 4 Programming Command Cross Reference
- 5 Example Programs
- A Syntax Diagram
- B Command Difference between E6392A & E6392B
- Index
112 Chapter 3
Programming Command Reference
TESTs Subsystem for MANUAL TEST
This command defines a measurement mode. The choices are SYNC for the
synchronous mode and ASYNC for the asynchronous mode. At preset, this is set to
SYNC.
NOTE For Test Sets with Option 002, this command is valid.
Measurement Mode
TESTs:MANual:MODE SYNC|GPRS
TESTs:MANual:MODE?
This command defines a measurement mode. The choices are SYNC for the
synchronous mode and GPRS for the GPRS mode. At preset, this is set to SYNC.
NOTE For Test Sets with Option 040, this command is valid.
Measurement Mode
TESTs:MANual:MODE SYNC|ASYNC|GPRS
TESTs:MANual:MODE?
This command defines a measurement mode. The choices are SYNC for the
synchronous mode, ASYNC for the asynchronous mode, and GPRS for the GPRS
mode. At preset, this is set to SYNC.
NOTE For Test Sets with Option 002 and Option 040, this command is
valid.
Midamble
TESTs:MANual:MIDamble
NONE|TSC0|TSC1|TSC2|TSC3|TSC4|TSC5|TSC6|TSC7
TESTs:MANual:MIDamble?
This command specifies a value of Training Sequence Code (TSC), TSC0 to
TSC7, or NONE for the amplitude trigger. At preset, this is set to TSC5.
NOTE If the mode is set to ASYNC on the Test Set with Option 002, this
command is valid.
MS Signal
TESTs:MANual:SIGNal BURST|CW
TESTs:MANual:SIGNal?
For Test Sets with Option 002 and if the ASYNC mode is selected, this command
defines a signaling type from the mobile when an asynchronous mode test is going
to be done. The choices are BURST and CW. At preset, this is set to BURST.
NOTE For Test Sets without Option 002, this command is invalid.