Technical data

Programming With TestExec SL 3
E6198B Switch/Load Unit Software Manual 3-3
Configuring an Agilent E6198B Switch/Load Unit
Figure 3-14 The parameters that can be configured of an Agilent E6198B
Switch/Load Unit.
Name of switch /load unit.
This is the name referenced
in a testplan
Click on checkbox, if not
checked, to enable switch/
load unit to be accessible
from testplans
Description of switch /load unit .
Change if needed.
Descriptive keyword to aid in
finding the switch /load box in
the system .ust file
Parameter block data for the switch /
load unit. (See example below .)
Click on the checkbox, if not checked ,
to automatically generate the wires
and aliases for the switch /load unit.
Show the ICA connection for either
the Test System Interface ICA type
(TC, HP, CC), the Mass Interconnect
ICA type (1-21) or the L2000
Interconnect ICA type (1-25),
depending on what System Database
Files are used .
Click on checkbox to generate
optional wires (for Mass
Interconnect ICA type only )
Selects connector number to
where load channels are wired
(see example below )
Show starting pin number ,
dependent on what ICA is used .
Field is usually grayed out since
this value depends on the ICA type
Click on “Help” to select this
help topic
Click on “Cancel” to cancel
changing/adding a load card
Click on “OK” to save the
load card data