Specifications

2-4 TS-8900 Functional Test System Diagnostics User Guide
2 Safety and Regulatory Information
Ground The System
To minimize shock hazard, the instrument chassis and cover
must be connected to an electrical protective earth ground. The
instrument must be connected to the ac power mains through a
grounded power cable, with the ground wire firmly connected
to an electrical ground (safety ground) at the power outlet. Any
interruption of the protective (grounding) conductor or discon-
nection of the protective earth terminal will cause a potential
shock hazard that could result in personal injury.
Fuses
Use only fuses with the required rated current, voltage, and
specified type (normal blow, time delay). Do not use repaired
fuses or short-circuited fuse holders. To do so could cause a
shock or fire hazard.
Operator Safety Information
Cables and connectors are considered inaccessible if a tool (e. g.
screwdriver, wrench, socket, etc. ) or a key (equipment in a
locked cabinet) is required to gain access to a conductive sur-
face connected to any cable conductor (High, Low or Guard).
Verify there are multiple and sufficient protective means (rated
for the voltages you are applying) to assure the operator will
NOT come into contact with any energized conductor even if
one of the protective means fails to work as intended. For exam-
ple, the inner side of a case, cabinet, door cover or panel can be
covered with an insulating material as well as routing the test
WARNING
In order to avoid electrical hazards, all system internal fuses must
be replaced by trained and qualified personnel.
WARNING
M
Module connectors and Test Signal cables connected to them
cannot be operator accessible.
WARNING
Assure the equipment under test has adequate insulation
between the cable connections and any operator-accessible parts
(doors, covers, panels shields, cases, cabinets, etc. )
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com