Specifications

94 Action Summary Chapter 5
PinRelayOpenTestAll Tests all of the Pin Matrix Modules for stuck open relays.
PinRelayPathTest Tests the Pin Matrix Module for stuck open relays.
PinRelayPathTestAll Tests all the Pin Matrix Modules for stuck open relays.
PinReset Reset Pin Matrix Module relays.
PinShortsTest Test for shorts between pins on the Pin Matrix Module.
PinShortsTestAll Test for shorts between pins on all of the Pin Matrix Modules in the system.
VI Debug Port Test Tests debug ports 1-4 of the MCM using the DMM.
VI HV DC Accy Tests HV DC source accuracy of the MCM using the DMM.
VI LV DC Accy Tests LV DC source accuracy of the MCM using the DMM.
VIRelayTest1 Tests bus 1, 2 and UUTCOM matrix relays for opens and shorts in the MCM.
VIRelayTest2 Tests bus 3 and 4 matrix relays for opens and shorts in the MCM.
whichDmm
This action returns the system DMM as follows:
0 - No system DMM found
1 - E1411 with MCM
2 - 34401 with E8792 mux
Table 5-5. digitizer Actions
digitalReadRegCC Low-Level Action: Reads a value from the specified E8794A custom card
digital input register.
digitalWriteRegCC Low-Level Action: Write a value to the specified Agilent E8794A Custom
Card digital output register.
digitalWriteRegQueryCC Low-Level Action: Returns the last value written to the specified register on
the Agilent Technologies E8794A custom card .
Low-Level Actions
ADCClear Clears output buffer on digitizer (ADC) and aborts reading, if in progress.
ADCConfArm Configures the arm subsystem of the E1563, E1564, or E1429 Digitizers.
ADCConfFreq Configures the frequency subsystem of the E1563, E1564, or E1429
Digitizer (ADC).
ADCConfInControls Configures the input circuit of the E1563, E1564, or E1429 Digitizer (ADC).
ADCFastOff This action shuts off the Agilent1429 Digitizer's fast fetch mode until it is
re-opened.
ADCGetSampleFreq Returns the sample rate values from the most recent setup of the Agilent
E1429 Digitizer.
ADCGetSampleInfo Returns sample rate and data point count values from the most recent
setup of the Agilent E1429 Digitizer (ADC).
ADCInitiate Arms the E1563, E1564, or E1429 Digitizer (ADC) and retrieves the data
after triggering occurs.
ADCIsSet Waits until the E1563, E1564, or E1429 Digitizer (ADC) is ready for
measurement.
Table 5-4. dgn (Diagnostic) Actions
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com