Specifications

Planning System Testplans 57Chapter 3
Look at the System Topology Layer of the Agilent TestExec SL
Switching Configuration Editor for ICA IDs in your system.
Thought needs to be given to Matrix module allocation. If Matrix
module resources are not in short supply, it may be helpful to wire a
Matrix module resource to each UUT pin. This allows the most
flexibility to handle board design or testing strategy changes. If you do
not have enough Matrix module channels to assign one to each UUT
pin, you will need to be more selective in making the assignments.
For a UUT ground pin, a Matrix module UUT Common pin, signal
pin, and earth ground should be wired to connect the system's UUT
Common and UUT ground, to earth ground and provide a way to
allow sensing.
3. If the test requires a load which is not currently configured in the
load box, analyze the load requirements for peak current and load size
to determine which type of load card to use. Then add the description
of the load to the Load Wiring Table of the Agilent TS-5400 System
Description Worksheet.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com