Specifications

How to Use the System Software 35Chapter 2
VXI Technology E1563A
Digitizer
Figure 2-15 shows the debug front panel for the VXI Technology E1563A
Digitizer. Only the UUT connection screen is shown. The custom path
selection is the same as for the Agilent E1411B Digital Multimeter (see
“Agilent E1411B Digital Multimeter” on page 30).
The debug panel boxes and buttons do the following:
Time Base and Range:
The range and timebase can be modified by selecting the “arrow” keys
on the side and bottom of the waveform. To update the display, take a
new measurement.
The time base allows the following range of selections:
50 nS to 20 Sec in 1, 2, 5 steps
the range has the following selections:
0.1 to 100 volts in 1, 2, 5 steps.
When the dialog box is brought up, the combo box contains the current
time base and range. All of the setting for the digitizer are saved until
an actual sweep is initiated.
Input and Triggering:
These two sections allow you to set a variety of input and trigger
functions. The setting of each function is sent when a measurement is
made.
Switching Path:
The debug panel supports the selection of a switching path. The
digitizer switches both the high and low connections of the output.
Figure 2-15. VXI Technology E1563A Digitizer Debug Front Panel
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com