Specifications

Action Summary 103Chapter 5
Table 5-13. switch Actions
Low-Level Actions
GetLoadCardID Reads the configuration register of the load box.
hardResetSU Reset all Agilent E6198 switch units and all cards contained therein.
SUreset Perform a soft reset on the Agilent Technologies E6198 switch unit.
High-Level Actions
switching This action connects / disconnects up to 10 switching paths.
Table 5-14. Load Card Actions
loadCardGetInfo Returns information about the loADCard referenced by the instrument
handle parameter.
loadCardReset Routine to reset a given load card.
loadCardTest Validates that a relay is set to a given position.
Table 5-15. SerialProtocol (Automotive Serial Protocol) Actions
CANGetInfo Gets information on current state of J1939 or CAN interface including Bit Rate,
Mode and Header Style (11 or 29 bit version).
CANRead Reads CAN bus.
CANSetBitRate Sets J1939 or CAN Interface bit rate in Bits/Sec.
CANSetIdMode Sets Header Style (11 or 29 bit version).
CANSetReadFilter Setup the CAN read filter.
CANSetTermination Sets 124 ohm termination resistor across CAN bus (from CAN+ to CAN-).
CANSetUp Performs general purpose set-up of CAN/J1939 protocol.
CANWrite Writes to CAN bus.
CANWriteAlternate Writes to CAN bus.
ISO9141EchoKeyword Provides detection for 2 keywords and echos the complement keyword #2 as
specified in ISO9141-2.
ISO9141FRead Reads ISO9141 formatted data.
ISO9141FReadConfig Constructs ISO9141 frame for the "ISO9141FRead" and "ISO9141Read"
actions.
ISO9141FWrite Writes formatted ISO9141 data.
ISO9141FWriteConfig Configuration parameters for ISO9141 formatted write action.
ISO9141GetInfo Gets information on the configuration and mode of operation of the ISO9141
serial interface device.
ISO9141InitSeq Initializes the ISO9141 sequence.
ISO9141Read Reads unformatted ISO9141 data.
ISO9141SetBitRate Sets the bit rate of the ISO9141 serial protocol interface.
ISO9141SetByteTime Sets the time delay between bytes in an ISO9141 message.
ISO9141SetUp Provides general purpose set-up of ISO9141 protocol.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com