Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide
Notices © Keysight Technologies 2013-2014 No part of this manual may be reproduced in any form or by any means (including electronic storage and retrieval or translation into a foreign language) without prior agreement and written consent from Keysight Technologies as governed by United States and international copyright laws. Manual Part Number E5864-97001 Edition Second Edition, November 2014 Printed in Malaysia Published By: Keysight Technologies Plot No.
Safety Summary The following general safety precautions must be observed during all phases of operation of this instrument. Failure to comply with these precautions or with specific warnings or operating instructions in the product manuals violates safety standards of design, manufacture, and intended use of the instrument. Keysight Technologies assumes no liability for the customer's failure to comply with these requirements.
CAUTION WARNING A CAUTION notice denotes a hazard. It calls attention to an operating procedure, practice, or the like that, if not correctly performed or adhered to, could result in damage to the product or loss of important data. Do not proceed beyond a CAUTION notice until the indicated conditions are fully understood and met. A WARNING notice denotes a hazard.
Symbol Description Equipotentiality N Neutral conductor on permanently installed equipment L Line conductor on permanently installed equipment On (mains supply) Off (mains supply) Standby (mains supply).
Symbol Description Ionizing radiation CAT I IEC Measurement Category I CAT II Measurement Category II CAT III Measurement Category III CAT IV Measurement Category IV Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide 6
Compliance and Environmental Information Table 2 Compliance and Environmental Information Safety Symbol Description CSA is the Canadian certification mark to demonstrate compliance with the Safety requirements. The C-tick mark is a registered trademark of the Spectrum Management Agency of Australia. This signifies compliance with the Australia EMC Framework regulations under the terms of the Radio Communication Act of 1992. CE compliance marking to the EU Safety and EMC Directives.
Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide 8
Contents 1 Handling the Removable Hard Drive Protecting Against Electrostatic Discharge (ESD) 11 Protecting Against Contamination of the Edge Connector Protecting Against Physical Shock 12 11 2 Installing the Hard Drive Step 1. Back up data for transfer to new hard drive 14 Step 2. Power OFF the 16850 logic analyzer 14 Using the Windows Shutdown 15 Using a Short Press of the Power Button 15 Using a Long Press of the Power Button 15 Unplugging the Power Cord or Power Loss 16 Step 3.
Contents 10 Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide
Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide 1 Handling the Removable Hard Drive For the integrity of the data on your hard disk drive, Keysight recommends that you take the following precautions while handling and storing the hard disk drives: • Store unused hard disk drives in the shipping container. • Protect the hard disk drive from electrostatic discharge (ESD). • Protect the hard disk drive’s edge connectors from physical contamination.
1 Handling the Removable Hard Drive Protecting Against Physical Shock CAUTION 12 While operating, do not expose the hard disk drive to more than 5 to 500 Hz at 0.3 g rms.
Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide 2 Installing the Hard Drive Step 1. Back up data for transfer to new hard drive / 14 Step 2. Power OFF the 16850 logic analyzer / 14 Step 3. Remove the current hard drive / 16 Step 4. Install the new hard drive / 18 Step 5. Power on the 16850 logic analyzer / 19 Step 6. Perform the first-time set up steps / 19 Step 7. Perform the first-time set up procedures / 19 Step 8. Restore data / 19 Step 9.
2 Installing the Hard Drive Step 1. Back up data for transfer to new hard drive 1 Close the Keysight Logic and Protocol Analyzer application software. 2 Back up any data and server license files you want to retain using LAN, USB flash drive, writable CDs, etc. Keysight recommends floating licenses for logic analyzers with removable disks (such as the 16850-series logic analyzers).
Installing the Hard Drive 2 Using the Windows Shutdown On the logic analysis system desktop, click Start > Shut Down or if you are running remote desktop, click Start > Settings > Windows Security > Shut Down. This software power off does the following: • Closes all programs that are running. • Writes all data to the disk. • Turns off the power supply. • If the system is unplugged while it is off and then plugged back in, the system will not power on until the power button is pressed.
2 Installing the Hard Drive Unplugging the Power Cord or Power Loss Unplugging power while the instrument is turned on or a power loss is similar to the long press of the power button with one exception: • When the system is plugged back in, it will power up and boot into Windows. Step 3. Remove the current hard drive The 16850 logic analyzer has a removable hard disk drive. It can be removed and replaced without disassembling the instrument.
Installing the Hard Drive 2 2 Pull the drive tray out to remove the disk drive.
2 Installing the Hard Drive Step 4. Install the new hard drive 1 18 Slide the new removable hard drive into the drive bay. 2 Gently press the tray all the way in to seat the disk drive connectors. 3 Tighten both the thumb screws that hold the hard disk drive in place.
Installing the Hard Drive 2 Step 5. Power on the 16850 logic analyzer Turn on the logic analyzer. Step 6. Perform the first-time set up steps If you are using the E5864A replacement hard disk as an additional bootable drive, the replacement disk is pre-configured with the operating system, frame drivers, and logic and protocol analysis application software (just like the original 16850 disk as shipped from the factory).
2 20 Installing the Hard Drive Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide
Keysight E5864A Removable Hard Drive for 16850-Series Logic Analyzers Installation Guide 21
This information is subject to change without notice. © Keysight Technologies 2013-2014 Second Edition, November 2014 *E5864-97001* www.keysight.
