User`s guide

Chapter 2 61
Installing the E5810
Installing and Configuring the Agilent IO Libraries
 If the IO icon is not displayed, a version may still be installed. To
check this, click
Start | Programs and look for the Agilent
IO Libraries program group.
 If this group is displayed, click Agilent IO Libraries |
IO Control
to display the IO icon. Then, click the icon and click
About Agilent IO Libraries Control to display the
installed version (must be L.01.01 or greater).
 If neither the IO icon nor the Agilent IO Libraries program group is
displayed, no Agilent IO Libraries are installed and you can use
the steps in this chapter to install the libraries.
 If a version of the libraries less than L.01.01 is installed, do not use
the steps in this chapter. Instead, use the steps in Appendix B -
Using the Agilent IO Libraries.
2 Turn the PC ON and, as required, install application software such
as C/C++, VEE, etc. on your PC.
3 Insert the Agilent IO Libraries for Instrument Control CD into the
CD-ROM drive and wait a few seconds for the application to run.
4 The installer should automatically start when the CD is inserted.
If not, select
Start | Run and browse to and select Setup.exe
on your CD-ROM. Click
Open to run the application.
5 The InstallShield
®
Wizard appears to begin the installation.