User`s guide

Chapter 2 47
Installing the E5810
Configuring the E5810 on a Local Network
Configuring the
E5810 for Enterprise
Network Operation
You can check or set E5810 configuration parameters using the E5810
Web access that is accessed from your Web browser (Internet Explorer 4.0
or higher or Netscape Navigator 4.7 or higher). The steps to set E5810
configuration parameters are:
1
Display the Welcome Page. From your Web browser address line,
type
‘http://<E5810 IP Address>’, where <E5810 IP
Address
> is the IP address displayed on the E5810 front panel
display. Then, press the
Enter key to display the E5810 Welcome page.
For example, if the default IP address of 169.254.58.10 is displayed
on the E5810 front panel, typing http://169.254.58.10 on your
Web browser address line and pressing
Enter displays the E5810
Welcome page. The following figure shows a typical display.