User`s guide

Appendix B 143
Using the Agilent IO Libraries
Installing Custom Agilent IO Libraries
Installing Custom Agilent IO Libraries
This section shows steps to perform a custom installation of new Agilent
IO Libraries.
1 Turn the PC ON and, as required, install application software such as
C/C++, VEE, etc. on your PC.
2 Insert the Agilent IO Libraries for Instrument Control CD into the
CD-ROM drive and wait a few seconds for the application to run. The
installer should automatically start when the CD is inserted. If not,
select
Start | Run and type <drive>:setup.exe, where
drive is your CD-ROM drive.
3 The InstallShield
®
Wizard appears to begin IO Libraries installation.
4 After a few seconds, the
Title Screen appears.