User`s guide

3 E5810B Web Access
Viewing and Modifying the E5810B Configuration
52 E5810B User’s Guide
NOTE
• Most changes to the configuration parameters are not effective until
you select Save and Reboot E5810B.
• To reset the configuration to the factory default settings, press the
Preset button on the E5810B front panel for more than 10 seconds.
Tab le 3-1 E5810B configuration parameters description
Parameter Default setting Description
Dynamic Host Configuration
Protocol (DHCP)
ON DHCP is a protocol for assigning dynamic IP addresses to devices
on a network. DHCP supports a mix of static and dynamic IP
addresses.
DHCP ON (Default):
If the DHCP is turned on, the E5810B will try to obtain an IP
address from a DHCP server. If this fails, the E5810B will use its
static IP address. If the DHCP is turned on and a DHCP server is
found, the manually configured IP address, subnet mask, and
default gateway parameters are not used by the E5810B
during startup.
DHCP OFF:
If the DHCP is turned off or unavailable, the E5810B will use the
static IP address that may be inputted in the Configuring your
E5810B LAN/GPIB/USB Gateway page during startup. In this
case, the values for the IP address, subnet mask, and default
gateway shown in the Configured Value column of the page will
be used during startup.