User`s guide

2 Installing the E5810B
Configuring the E5810B on an Enterprise Network
28 E5810B User’s Guide
Configuring the E5810B for an Enterprise network operation
After the E5810B is installed on the Enterprise network, you
can set the required configuration parameters using the
E5810B Web access.
1 Go to your Web browser and type http://<hostname>
(if known) or http://<IP address> at the address line.
2 Select View & Modify Configuration from the E5810B Welcome
page to display the E5810B current configuration.
3 Select Modify Configuration and enter the password to
configure the E5810B. The default password is E5810.
4 The Configuring your E5810B LAN/GPIB/USB Gateway
page will be displayed.
5 To configure the E5810B for use on an Enterprise
network operation, refer to
Table 2- 1 for the required
configuration parameters.
NOTE
Refer to Chapter 3, “E5810B Web Access” for more information in
configuring the E5810B parameters using the E5810B Web access.