User`s guide

2 Installing the E5810B
Configuring the E5810B on a Local Network
26 E5810B User’s Guide
Configuring the E5810B for a local network operation
This section provides the guidelines to configure the E5810B
on a local network or eventual installation on a non- DHCP
Enterprise network.
The first step in configuring the E5810B on a local network
is to establish communication between your PC and the
E5810B. The PC and the E5810B must be on the same
subnet in order to establish a connection.
To place the PC and the E5810B on the same subnet, type in
route add <E5810B IP address> <PC IP address> in
the MS-DOS prompt program.
For example, if the PC IP address is 155.139.103.152 and the
E5810B IP address is 169.254.58.10 (default), the commands
are as follows:
!route is lost when the PC is rebooted
route add 169.254.58.10 155.139.103.152
or
!route persists when the PC is rebooted
route -p add 169.254.58.10 155.139.103.152
After the connection is established, you can set the required
configuration parameters using the E5810B Web access.
NOTE
Refer to Chapter 3, “E5810B Web Access” for more information in
configuring the E5810B parameters using the E5810B Web access.