User`s guide

E5810B User’s Guide 113
Using the Telnet Utility A
Using the Telnet Utility
Use the following procedure to exit the Telnet utility.
1 If you want to exit without saving any changes (if any)
you have made to the configuration values, type bye,
exit or quit at the Telnet prompt (>).
2 If you want to save the changes you have made to the
configuration values via the Telnet utility, type reboot at
the Telnet prompt (>).
To reset the E5810B to the default configuration values and
reboot the E5810B, type factory-reset at the Telnet
prompt (>).
A typical display screen for an E5810B is shown below. The
configuration values you see for your E5810B will probably
be different.
CAUTION
Any client operations in progress and client connections will be
terminated by the reboot command.
CAUTION
Any client operations in progress and client connections will be
terminated by the factory-reset command when it reboots the E5810B.
Welcome to the E5810B LAN/GPIB/USB Gateway Configuration Utility.
Controls GPIB, RS-232 and USB interfaces via the LAN
Commands
? View Available Commands
exit, quit Exit WITHOUT Saving Configuration Changes (see restart)
restart Save Configuration Changes and Restart E5810B
status View the LAN/GPIB/USB Gateway Connection Status
Read-only E5810B Parameters
hardware-addr: 44E8A5000121 # Ethernet(MAC) Address
serial-num: MY50360021 # Serial Number