User`s guide

Agilent Technologies E5500 Phase Noise Measurement System 5-1
5 Expanding Your Measurement Experience
What You’ll Find in This Chapter
•
Testing the Agilent/HP 8663A Internal/External 10 MHz,page5-10
(Conf_8663A_10MHz.pnm)
• Testing the Agilent/HP 8644B Internal/External 10 MHz,page5-33
(Conf_8644B_10MHz.pnm)
• Manual Measurement
• Viewing Markers,page5-56
• Omitting Spurs,page5-57
• Displaying the Parameter Summary,page5-59
CAUTION To prevent damage to the Agilent/HP 70420A test set’s hardware
components, the input signal must not be applied to the signal input
connector until the input attenuator has been correctly set for the desired
configuration, as show in Table 5-3 on page 5-17. Apply the input signal
when the connection diagram appears.