User`s guide

Agilent Technologies E5500 Phase Noise Measurement System 18-1
18 Reference Graphs and Tables
Graphs and Tables You’ll Find in This Chapter
Graphs • Approximate System Phase Noise Floor vs. R Port Signal Level,
page 18-2
• Phase Noise Floor and Region of Validity, page 18-3
• Phase Noise Level of Various Agilent/HP Sources, page 18-4
• Increase in Measured Noise as Ref Source Approaches UUT Noise,
page 18-5
• Approximate Sensitivity of Delay Line Discriminator, page 18-6
• AM Calibration, page 18-7
• Voltage Controlled Source Tuning Requirements, page 18-8
• Tune Range of VCO vs. Center Voltage, page 18-9
• Peak Tuning Range Required Due to Noise Level, page 18-10
• Phase Lock Loop Bandwidth vs. Peak Tuning Range, page 18-11
• Noise Floor Limits Due to Peak Tuning Range, page 18-12
Tables • Tuning Characteristics of Various VCO Source Options, page 18-13
• Agilent/HP 8643A Frequency Limits, page 18-14
• Agilent/HP 8644B Frequency Limits, page 18-16
• Agilent/HP 8664A Frequency Limits, page 18-18
• Agilent/HP 8665A Frequency Limits, page 18-20
• Agilent/HP 8665B Frequency Limits, page 18-22