User`s guide

Agilent Technologies E5500 Phase Noise Measurement System 9-9
Residual Measurement Examples
Amplifier Measurement Example
Figure 9-1 Setup diagram for the Agilent/HP 8349A Amplifier Measurement
Example.
• Microwave Phase Detectors 0 to +5 dBm (Signal Input)
+7 to +10 dBm (Reference Input)
CAUTION:
To prevent damage to the Agilent/HP 70420A Test Set’s hardware components,
the input signal must not be applied to the test set’s signal input connector until
the input attenuator (Option 001) has been correctly set by the phase noise
software, which will occur at the connection diagram.
Characteristics:
Input Impedance 50 ohm Nominal
Table 9-2 Agilent/HP 70420A Test Set Signal Input Limits and Characteristics