Installation guide

Agilent Technologies E5500A Installation Guide

1- 39

Welcome to the E5500A Phase Noise Measurement System Series of

Solutions

The appropriate measurement definition parameters for this example

have been pre-stored in this file. Table 1-5 on page 1-41 lists the

parameter data that has been entered for the Agilent/HP 70420A

Confidence Test example.

Beginning the

Measurement

1. From the Measure menu, choose New Measurement.

2. When the Perform a New Calibration and Measurement dialog box

appears, click OK.

3. When the Connect Diagram dialog box appears, connect the 50

Ω

termination provided with your system to the Agilent/HP 70420A Test

Set’s Noise Input connector. (See Figure 1-1.)

Figure 1-1 System Confidence Test Setup Diagram.

Ω

termination

goes here