Installation guide

Agilent Technologies E5500A Installation Guide 1- 23
Welcome to the E5500A Phase Noise Measurement System Series of
Solutions
7. From the Asset Type pull-down list, select Test Set, then click the Next
button.
8. Click on Agilent/HP 70420, then click the Next button.
9. From the Interface pull-down list, select GPIB0.
10. In the Address box, type 20. 20 is the default address for the
Agilent/HP 70420A phase noise test set.
The following are default device addresses used by Agilent Technologies.
Table 1-3 Default Device Addresses
Instrument
Address
Agilent/HP 70420A Test Set 20
Agilent/HP 70421A
Downconverter
28
Agilent/HP 70422A
Downconverter
28
Agilent/HP 70427A
Downconverter
28
RF Analyzer 17
FFT Analyzer 18
Source # 1 19