Installation guide

Agilent Technologies E5500A Installation Guide 1- 19
Welcome to the E5500A Phase Noise Measurement System Series of
Solutions
Step 5. Installing the Windows NT 4.0 Service
Pack
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-35.
1. Make sure your computer and monitor are turned on.
2. Place the E5500 Phase Noise Measurement Software CD-ROM in the
CD-ROM drive.
3. The following dialog box will appear.
4. Double-click on Service Pack, then on Update,thenonUpdate.exe and
follow the instructions (accept the default settings).
5. Reboot your computer at this time.