Installation guide

1-6 Agilent Technologies E5500A Installation Guide
Welcome to the E5500A Phase Noise Measurement System Series of
Solutions
Step 2. Installing the Hardware
NOTE If you have ordered a preconfigured phase noise system from Agilent
Technologies, skip this step and proceed to “Step 9. Starting the
Measurement Software” on page 1-35.
Installing the phase noise hardware into your computer involves the
following steps:
Step 2a - Removing your Computer’s Cover, page 1-7
Step 2b - Accessing your Computer’s ISA Slots, page 1-8
Step 2c - Taking ESD Precautions, page 1-9
Step 2d- Installing the Interface Cards, page 1-10
Step 2e - Replacing the Computer Cover, page 1-12