Specifications

34
6. Start New Measurement.
a) Select New Measurement from the Measure
pulldown menu.
b) At the connect diagram, check hardware and
connect the signal path to the signal input of
the phase noise test set.
c) Select Continue.
d) When prompted by the software, connect the
calibration signal from the calibration source
to the coupler, then select Continue.
e) When prompted by the software, disconnect
the calibration signal from the calibration
source, then select Continue.
7. When the measurement is complete, print the
results and save the measurement file.
Figure 4-3. AM noise of an Agilent 83732B under
pulsed carrier conditions