Installation guide

Agilent Technologies E5500B Installation Guide 1-13
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 2e - Replacing the
Computer Cover
17. Replace the computer cover as described in your computer’s
documentation.
18. Connect the following cables between the PC digitizer and the
Agilent/HP 70420A Test Set:
❍ SMB (f) to BNC (m) cable between the PC digitizer interface card
adapter’s input
connector and the Agilent/HP 70420A Test Set’s
front-panel <100 kHz output connector.
❍ SMB (f) to BNC (m) cable between the PC digitizer interface card
adapter’s output
connector and the Agilent/HP 70420A Test Set’s
rear-panel Noise Source Input connector.
19. Refer to the following system connect diagram examples for more
information about system interconnections:
❍ “E5501B Connect Diagram Example” on page 1-14
❍ “E5502B/3B/4B Connect Diagram Example” on page 1-15