Installation guide

1-10 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
Step 2d- Installing the
Interface Cards
Installing the GPIB Interface Card
10. Insert the GPIB interface edge connector into the expansion slot
connector of the computer. Make sure the interface is fully seated by
pushing firmly on the edge of the card with the palm of your hand. The
GPIB connector should extend through the back panel opening to allow
cable installation.
NOTE Use of a GPIB connector extender may be necessary for adequate clearance
between the GPIB cable and the computer chassis.
11. Replace the GPIB back-panel cover plate screw to hold the interface in
place. (Save the blank cover plate for use if the interface is removed
later.