Installation guide

1-2 Agilent Technologies E5500B Installation Guide
Welcome to the E5500B Phase Noise Measurement System Series of
Solutions
What You’ll Find in This Chapter...
•
“Introduction” on page 1-3
• “System Requirements” on page 1-4
• “Step 1. Unpacking Your System” on page 1-5
• “Step 2. Installing the Hardware” on page 1-6
• “Step 3. Installing the I/O Libraries” on page 1-16
• “Step 4. Installing the PC-Digitizer Software” on page 1-19
• “Step 5. Installing the Windows NT 4.0
“
Service Pack” on page 1-20
• “Step 6. Installing the Measurement Software” on page 1-22
• “Step 7. Using the Asset Manager to Configure your System” on page
1-23
• “Step 8. Entering the License Key for the Phase Noise Test Set” on page
1-33
• “Step 9. Starting the Measurement Software” on page 1-36
• “Step 10. Using Server Hardware Connections to Specify Assets for the
Confidence Test” on page 1-37
• “Step 11. Running the Software Confidence Test” on page 1-39