User`s guide

Table Of Contents
Chapter 13 369
SCPI Command Reference
E5061A/E5062A commands
13. SCPI Command
Reference
:SENS:CORR:IMP
Syntax :SENSe:CORRection:IMPedance[:INPut][:MAGNitude] <numeric>
:SENSe:CORRection:IMPedance[:INPut][:MAGNitude]?
Description Sets the system characteristic impedance (Z0) value.
NOTE This command is available with the firmware version 3.01 or greater.
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Example of use
10 OUTPUT 717;":SENS:CORR:IMP 75"
20 OUTPUT 717;":SENS:CORR:IMP?"
30 ENTER 717;A
Equivalent key [Cal] - Set Z0
<numeric>
Description System Z0 value
Range 1E-3 to 1000
Preset value 50 or 75
Unit Ω (ohm)
Resolution 0.001