User`s guide

308 Chapter 13
SCPI Command Reference
E5061A/E5062A commands
:DISP:COL{1-2}:LIM{1-2}
Syntax :DISPlay:COLor{[1]|2}:LIMit{[1]|2} <numeric 1>,<numeric 2>,<numeric 3>
:DISPlay:COLor{[1]|2}:LIMit{[1]|2}?
Description Sets the fail display color used for the limit test result (:LIM1) and the color of the limit
line (:LIM2) for normal display (:COL1) and inverted display (:COL2).
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric 1},{numeric 2},{numeric 3}<newline><^END>
Example of use
10 OUTPUT 717;":DISP:COL1:LIM1 1,2,3"
20 OUTPUT 717;":DISP:COL1:LIM1?"
30 ENTER 717;A,B,C
Related commands :DISP:COL{1-2}:RES on page 308
Equivalent key
[System] - Misc Setup - Color Setup - Normal|Invert - Limit Fail|Limit Line
:DISP:COL{1-2}:RES
Syntax :DISPlay:COLor{[1]|2}:RESet
Description Resets the display color settings for all the items to the factory preset state for normal
display (:COL1) and inverted display (:COL2). (No query)
Example of use
10 OUTPUT 717;":DISP:COL1:RES"
Related commands :DISP:COL{1-2}:BACK on page 306
:DISP:COL{1-2}:GRAT{1-2} on page 307
:DISP:COL{1-2}:LIM{1-2} on page 308
:DISP:COL{1-2}:BACK on page 306
:DISP:COL{1-2}:BACK on page 306
Equivalent key
[System] - Misc Setup - Color Setup - Normal|Invert - Reset Color - OK
<numeric 1> <numeric 2> <numeric 3>
Description Amount of red Amount of green Amount of blue
Range 0 to 5 0 to 5 0 to 5
Resolution 1 1 1