User`s guide

Chapter 13 279
SCPI Command Reference
E5061A/E5062A commands
13. SCPI Command
Reference
:CALC{1-4}:MARK{1-10}:X
Syntax :CALCulate{[1]|2|3|4}[:SELected]:MARKer{[1]|2|3|4|5|6|7|8|9|10}:X <numeric>
:CALCulate{[1]|2|3|4}[:SELected]:MARKer{[1]|2|3|4|5|6|7|8|9|10}:X?
Description For the active trace of channel 1 (:CALC1) to channel 4 (:CALC4) (specified with the
:CALC{1-4}:PAR{1-4}:SEL command), sets the stimulus value of marker 1 (:MARK1) to
marker 9 (:MARK9) and reference marker (:MARK10).
Parameters
If the specified parameter is out of the allowable setup range, the minimum value (if the
lower limit of the range is not reached) or the maximum value (if the upper limit of the
range is exceeded) is set.
Query response {numeric}<newline><^END>
Example of use
10 OUTPUT 717;":CALC1:MARK1:X 1E9"
20 OUTPUT 717;":CALC1:MARK1:X?"
30 ENTER 717;A
Related commands :CALC{1-4}:MARK{1-10}:Y? on page 280
:CALC{1-4}:PAR{1-4}:SEL on page 286
:CALC{1-4}:MARK:REF on page 262
Equivalent key
[Marker] - Marker 1|Marker 2|Marker 3|Marker 4|Ref Marker
[Marker] - More Markers - Marker 5|Marker 6|Marker 7|Marker 8|Marker 9
NOTE When performing the operation from the front panel, you turn ON the marker and set the
stimulus value at the same time.
<numeric>
Description
Stimulus value
*1
Range
Sweep start value to sweep stop value
*2
Preset value
Sweep start value
*3
Unit Hz (hertz), dBm or second
*1.When the reference marker mode is ON (ON is specified with the
:CALC{1-4}:MARK:REF command), it is the value relative to the reference marker.
*2.When the span value of the sweep range is 0, the range is from 0 to sweep time value.
*3.When the span value of the sweep range is 0, the unit is 0.